The trouble with electronics is that it can easily breakdown at any given time. It never gives you a warning, although, they do show signs, and that is what is wrong with mankind. We tend to neglect what our devices show us, telling us something is wrong, but we never mind. Instead, we continue using it and then later on we complain about the device being weak. Nonetheless, it is still a device that is worth salvaging, and before doing any intervention to try and make it work, assessment is the key. After which, you have to do the simplest of things before you proceed to spending a little amount for repairs or purchasing parts. Again, this can be a process called troubleshooting and sometimes, one of the more common problems that need troubleshooting is the iPad 4 digitizer. Why highlight the digitizer installed in the 4th installment of Apple’s tablet series? Basically because it is the most recent among all the tablets that Apple has released, this will soon be replaced by its 5th installment. In addition, the iPad 4 has been considered to be one of the weakest when it comes to its parts’ endurance. This also includes the iPad 3. They just do not make the same kind of tablets as they did before. Again, nonetheless, nothing can be done about since Apple will continue its trend and people will continue buying them. When using the following troubleshooting techniques, you need to remember that this is prompted by the following instances: a) Dead spots located on the screen of your iPad 4; b) Phantom touch syndrome, which is basically your screen opening applications at random without you touching them. So anyway, what you could to check if a problem really exists is to do a hard reset. This is done by holding down the power button and the home button for 15 seconds until you see the Apple logo. Contrary to what you might think however, this is not a solution for youriPad 4 digitizer breaking down. This is just a way to troubleshoot the problem. You may re-seat the digitizer cable of your iPad, but first, you have to make sure that the cable is not dusty. This can be resolved by basically using a can of pressurized air and praying it over the cable. When re-seating the cable, you have to make sure that at the end of the adjustment, the white line should be in line with the edge of the logic board connector. After doing so, put the iPad back together before testing it again. If the previous suggestions does not help, then you must now seriously think about buying a replacement iPad 4 digitizer, then, replace the digitizer which is installed in your tablet before trying it again. If after testing it works, then the problem lies within your original digitizer which you should think about reporting so that it will come to the awareness of the company. Yes, technology has a way of disappointing those who trusts it, and sometimes, it will cost anyone more money. However, you cannot deny the kind of help that it does. For more information please visit Get Online Digitizer for iPad 4
|